Sagem MF 3780 User Manual download pdf (Page 152)

Contents

Date en cours : 29 juin 2004

D:\CLIENTS\sagem\Pour dossier MFK V2\MFK V2 LU 251597054A MF3760_3780 GB\MaintenanceGb.fm

Transmission from memory

You have the choice between:

• waiting until the transmission takes place at the given time

• restarting the transmission using the transmission queue reportez-vous au paragraphe Immedia-

tely perform transmission from the waiting queue, page 5-11). In this case, for a document

composed of several pages, the transmission will take place from the page where the error occur-

red

• abandoning the transmission by deleting the corresponding command in the transmission line

(reportez-vous au paragraphe Deleting a transmission on hold, page 5-12).

The terminal makes at most 5 automatic redials. The non-transmitted document is automatically deleted

from the memory and a transmission report is then printed together with an error code and the cause for

transmission failure (see the communication error codes).

Communication error codes

The communication error codes appear in the logs and transmission reports.

General codes

Code 01 - Busy or no fax answer

This code appears after 6 unsatisfactory attempts. Call later.

Code 03 - User break

A communication has been stopped by the user pressing the key.

Code 04 - Non programmed number

A number saved as a one-touch key or abbreviated number is not valid-check it. (Example: a delayed

transmission was programmed with a one-touch key and this key has been deleted in the meantime).

Code 05 - Scanning default

An incident occurred with the scanner, for example, the sheet is jammed.

Code 06 - Printer default

An incident occurred in the printer: no paper, paper jam, opened cover... In the reception mode, this

incident appears only if the reception parameter is switched to

WITHOUT PAPER (reportez-vous au

paragraphe Reception without paper, page 3-5).

Code 07 - Disconnected

The link has been cut (bad line). Check the number and try again.

Code 08 - Quality

The document you sent was not well received. Contact your subscriber to see if you need to send again.

Code 0A - No document to be polled

You tried to poll a document from a subscriber who had not prepared his document (no deposit) or the

password entered was incorrect.

Code 0B - Wrong number of pages

There is a difference between the number of pages indicated during preparation for the transmission

and the number of pages sent- check the number of pages in the document.

1 2 ... 147 148 149 150 151 152 153 154 155 156 157 ... 170 171

No comments

Sagem MF 3780 User Manual Page 152