Sagem myX3-2 User Manual download pdf (Page 16)

Activating your phone

Your phone is powered by a rechargeable battery. A new

battery must be charged for at least 4

hours before being

used for the first time. It reaches its optimum capacity

after a few cycles of use.

When your battery has been discharged, the phone

displays the state (empty battery icon flashes). In this

case recharge your battery for at least 15 minutes before

making any more calls so as to avoid being cut off mid-

call.

To recharge the battery:

Connect the charger to a mains socket.

Plug the end of the cable into the connector at the base of

the phone.

The phone starts to charge up. Charging stops by itself.

Disconnect the cable.

It is possible that the battery may heat up slightly during

charging; this phenomenon is normal.

Charging the battery

WARNING

There is danger of explosion if the battery is replaced incorrectly or if it is exposed to fire.

Do not short circuit it.

The battery does not have any part that you can change.

Do not try to open the battery casing.

Use only the appropriate chargers and batteries shown in the manufacturer's catalogue.

Used batteries must be disposed of in the appropriate places.

It is advisable to remove the battery if your phone is not used for extended periods.

251400892 myX3-2 English.book Page 13 Jeudi, 27. novembre 2003 2:10 14

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 78 79

No comments

Sagem myX3-2 User Manual Page 16