Sagem myX3-2 Technical Information download pdf (Page 81)



Proc Sheet 1 07

myX3-2

REMOVING / REPLACING THE BATTERY

CONNECTOR

1/2

________________________________________________________________________________________________

Ref. SCT U38 SSC DTS 0014 – Index B - March 30, 2004 Page 5-28

4.51 Tools :

- A 0.6mm torx screwdriver

- Tweezers

4.52 Preliminary operation

1. Remove the back cover ( Proc sheet 0 01).

2. Remove the battery ( Proc sheet 0 02).

3. Remove the front cover ( Proc sheet 0 03).

4. Unscrew the six attachment screws on the electronic board.

5. Remove the assembly display , then the light guide keypad (Proc sheet 1 02 / 1 03)

6. Remove the electronic board.(Proc sheet 1 04)

4.53 Removal procedure :

1. Remove the battery connector (1) , using tweezers

4.54 Placement procedure :

1. Place the battery connector (1) in position in its housing, respecting the foolproof device.

4.55 Further operations :

1. Remove the electronic board on the assembly plate.(Proc sheet 1 04)

2. Replace the light guide keypad (Proc sheet 1.03)

3. Replace the assembly display (Proc sheet 1 02)

4. Position and tighten the six attachments screws with torque settings of 0,25 N.m.

5. Replace the front cover /battery / back cover (Proc sheet 0 01 / 0 02 / 0 03).

6. . Carry out the radio test (Test Sheet 06).

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 110 111

No comments

Sagem myX3-2 Technical Information Page 81