Sagem myX3-2 Technical Information download pdf (Page 98)

 Technical Site Documentation - myX3-2

________________________________________________________________________________________________

Ref. SCT U38 SSC

DTS 0014 – Index B - March 30, 2004

Page 6-

Before any operation,

-flux correctly the pins of the connector.

-with the solder wick loaded with tin , tin the pins of the

DATA/ AUDIO/ CHARGE connector by positioning it

straight ahead (pads upward), and by heating the solder

wick which is in touch with pins.

Attention:

- At the end of the operation , verify that there is no short

circuit between pads.

-Start soldering the connector pins.

-Flux the place of the connector and position the DATA/

AUDIO/ CHARGE connector.

-Verify that the pins of the DATA/ AUDIO/ CHARGE

connector are well centred on pads.

-Heat pins with an air blow device while maintaining the

connector with tweezers

-Verify that there is no short-circuit, that solders are shiny

At last, solder the 4 pins crossing the board..

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 110 111

No comments

Sagem myX3-2 Technical Information Page 98